Home/R&D

R&D and manufacturing

The engineering behind the charger

Phone charger boards are designed in-house and checked on dedicated benches, with cable and power bank assemblies built on the same lines. This page shows how a model moves from requirement to shipment.

GaN charger on a test bench with meters

Illustrative image — lab photography to be supplied

Engineer testing a charger with an oscilloscope
Charging protocol test bench with devices connected

Departments

Four teams, one development loop.

Electronics, industrial design, packaging and quality sit close enough that a change in one does not stall the others.

Charger circuit & protocol engineering

Phone charger boards, from 20W single-port models to 100W stations, are designed and iterated in-house, including PD, PPS and per-port power sharing.

Enclosure & packaging design

Industrial design, moulding for compact charger shells and retail packaging are developed alongside the electronics.

Test bench & reliability

Load, thermal, plug-cycle and protocol testing run on dedicated benches before a charger model is released.

Pre-production validation

Trial runs confirm assembly sequence, fixturing and inspection points before mass production.

Quality process

Test before it ships.

Five checkpoints between incoming components and dispatch. Each one has a written pass criterion rather than a visual once-over.

Certification reports and test summaries are issued per project.

To be provided

  1. 1

    Incoming component check

    Cells, connectors, ICs and shells are checked against approved samples on arrival.

  2. 2

    Board-level verification

    Output, protection and protocol behaviour are verified on the bench before assembly.

  3. 3

    In-line assembly checks

    Each station has a defined inspection point with recorded pass criteria.

  4. 4

    Functional & thermal test

    Finished units run charge and discharge cycles with temperature monitoring.

  5. 5

    Outgoing inspection

    Sampling per batch, carton marking and documentation are confirmed before dispatch.

Technology directions

Where the platform is heading.

01

GaN platforms

Higher switching frequency in a smaller body, with thermal paths designed around the enclosure.

02

Multi-port power sharing

Firmware budgets output across ports so devices negotiate the right profile automatically.

03

Thermal design for compact shells

Heat paths and derating curves are planned around the enclosure, so a phone charger keeps its size without running hot.

OEM / ODM process

From your requirement to a production line.

  1. 01

    Requirement review

    Target market, price band, volume and packaging needs.

  2. 02

    Design & tooling

    Enclosure, artwork and fixture planning.

  3. 03

    Sampling

    Functional samples with your branding for approval.

  4. 04

    Trial run

    Production-line validation of the agreed configuration.

  5. 05

    Mass production

    Scheduled output with in-line and outgoing inspection.

ISO 9001:2015

To be provided

ISO 14001:2015

To be provided

BSCI

To be provided

ETL / cTUVus

To be provided

FCC

To be provided

PSE

To be provided

SAA / RCM

To be provided

CE-LVD / CE-EMC

To be provided

RoHS

To be provided

UKCA

To be provided

BSMI

To be provided

KC / KCC

To be provided

CB

To be provided